The Progressive Dynamics RV Power Control Center # PD4135K is not going to be a direct replacement for your Magnetek 6325. Unfortunately there is not a direct replacement for the Magnetek 6325 available. The 25 amp converter with 12V power can be replaced with the Progressive Dynamics Inteli-Power RV Converter and Battery Charger - 12V - 30 Amps # PD9130 which will give you slightly more power. But most people with this model choose to upgrade their entire system and for that I would recommend... view full answer...
Yes, the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger at 75 Amps, # PD4575K18LS8, shows specs as follows:
Voltage
-AC distribution rating: 240 VAC
-Converter input: 105 - 130 VAC
-Converter output (no load): 13.6 VDC
-Converter output (full load): > 12.6 VDC
Rated power output of 1,020 watts view full answer...
Yes, you're correct that Progressive Dynamics started including the 2-stage charging function with their PD9100ALV line without changing the item number. I've personally ran through all of our inventory and of the available models of the PD9100ALV we currently have the Progressive Dynamics Inteli-Power RV Converter and Battery Charger 45 Amps # PD9145ALV and Progressive Dynamics Inteli-Power RV Converter and Battery Charger 60 Amps # PD9160ALV are the newer models with the 2-stage charging... view full answer...
We do have a 30 amp, 12 volt power converter, including one that can be used for either lithium or non-lithium batteries:
- Progressive Dynamics 9300 Series RV Converter Charger - 12V - 30A # PD49RR view full answer...
Yes, we have the Replacement Lithium Converter for Progressive Dynamics 4000 Series RV Power Control Center - 45 Amp, # PD4045LICSV. This upgrades or replaces the converter in your 45-amp Progressive Dynamics 4000 series Power Control Center to a lithium converter and designed to work with # PD4045KA. view full answer...
Along with your Mighty Cord 30 Amp Twist Lock RV Power Inlet # A10-30INVP you can use their mating replacement female Twist Lock Connector # A10-30FDT. If you care to add a weather-resistant locking ring you can also use part # A10-30CV. view full answer...
The Progressive Dynamics Inteli-Power RV Converter and Battery Charger - Lithium - 12V - 60 Amps # PD9160ALV we have are the 2021 version with 2-stage charging so you won't have to worry about receiving the older model that doesn't. view full answer...
I may have a solution for you to convert a manual awning to a powered awning, but I checked with Lippert on this and there is not a 63" version of the Solera 18v Power RV Awning Conversion Kit like the # LC434730.
However, if you're looking to convert from a manual awning to a powered awning you could use the Solera Smart Arm 12V Power RV Awning Conversion Kit - Programmable - 63" Arms - Black # LC759516 or Solera Smart Arm 12V Power RV Awning Conversion Kit - Programmable - 63" Arms -... view full answer...
The advantage or pro, of having a converter/charger in one unit, such as the Progressive Dynamics Mighty Mini Converter/Smart Charger, # PD4045KA is having it all in one package; you know that all subcomponents are matched to function with each other. The way the Go Power Inverter, # 34278156 that you linked to works is to be connected to your RV's AC battery bank providing 12 Volt DC output. That battery bank is charged from the AC input of the shore power connection, or solar, or generator.... view full answer...
It sounds like you need a converter so the 3 wire system on your vehicle works with the 2 wire system on your new LED tail lights. If that is the case, you can use the Hopkins Tail Light Converter - LED Compatible # HM48847. This installs on your vehicle wiring to combine your vehicle's independent brake light and turn signal functions. view full answer...
You will need to use a receiver like the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver # 41990-07 to mount to the frame on your 2004 Thomas Freightliner FS65 Conversion. This receiver will fit frames up to 44" wide and has a 7" tall mounting bracket to bolt or weld onto your frame. This class V receiver is rated for a tongue weight of 1,600lbs and trailer weight of 16,000lbs.
We also have the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver # 41990-16 that has a 16"... view full answer...
9-pin connectors are rare these days. We do still offer vehicle and trailer side connectors of this type, such as # PK12907 and # PK12906, but we do not have any adapters that can convert your truck's 7-way blade-style RV connector to a 9-pole round pin type. A 9-pole connector like # PK12906 has two extra circuits (auxiliary on the gray wire and reefer on the orange) that would not be supported if fed by a 7-way socket. You'll want to swap out the truck connector using part # PK12907. view full answer...
Progressive Dynamics just recently included 2-Stage charging in the Progressive Dynamics Inteli-Power RV Converter and Battery Charger - Lithium - 12V - 45 Amps # PD9145ALV so I went out to our warehouse to verify we already sold through the older version and have just the newer one now. I checked each box and all have the 2-Stage Charging Sticker on the side of the converter as you can see from the attached picture. view full answer...
We have the Better Bath RV Shower Pan - Right Hand Drain - 32" Long x 32" Wide - White, # LC209744. This RV shower pan has a right-hand side drain hole and a flange that prevents your wall from getting water damage. Durable ABS plastic construction is lighter and more eco-friendly than fiberglass. The pan's textured, anti-slip bottom prevents falls. The overall exterior dimensions are side to side, 32" long x 32" wide and a corner to corner of 44-7/8" long x 44-7/8" wide. The overall... view full answer...
There isn't a version of the Camco RV Power Defender Circuit Analyzer # CAM55310 that would allow you to connect your RV's 50 Amp power plug directly into a 30-amp receptacle at an RV park. You'll need to use a power cord adapter like # CAM55185, as you mentioned. view full answer...
RV manufacturers do not maintain detailed specs on smaller items such as the lights installed on their motorhome products but we do offer a full range of replacement lenses, complete light assemblies and also LED replacement "bulbs" that allow you to convert the RV to high-efficiency LED lighting without having to change all of the fixtures too.
I have linked for you our main pages for trailer light replacement lens parts, complete light fixtures and for the LED replacement elements.
The... view full answer...
To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins.
This can be done by using a female 7-pin socket # PK11720 to accept the plug from the semi, a tail light converter # 119178 and a female 7-way RV blade-style socket # PK12-707E. The converter would be wired in between both sockets to combine the brake light... view full answer...
While we do have an 11' wide option in the Solera, # LCV000334909-362243 that is a power RV awning, it is not a rechargeable option such as the # LC729486 Solera awning you linked to. This options' drive motor wires into the control switch, which can either be connected to your battery or wired directly into your RV by way of a converter.
For a new installation instead of replacement, you will need to install the Solera Awning Rail Extrusion, # LC715217. This comes in 8' lengths so you... view full answer...
We do not offer 6-pin wiring kits for your B Series pickup but we can offer you a solution for connecting your pop-up camper trailer. Since the majority of vehicles and RVs now use the 7-way blade style setup I suggest you install this type of wiring on the trailer.
This is a straightforward process using a 7-way/junction box combo item # HS381-9000. The junction box makes it easy to connect the trailer's existing wiring and to install the 7-way plug. Just match up the wires by function... view full answer...
For all intents and purposes the only difference between the Mighty Cord Replacement RV Power Inlet # A10-30INBKVP and the # 277-000137 is going to be the color. One is white and one is black. view full answer...
Go To Results